The Process

Three Steps. Zero Residue.

Vinyl Ripper is engineered for speed and clean results. Whether you're pulling a full wrap or a stubborn decal, the process is the same — heat, spray, peel.

Heat & Spray

140°F minimum — then immediately spray

Use a corded heat gun to bring the vinyl surface to at least 140°F. The moment the surface is up to temperature, immediately spray Vinyl Ripper directly onto the heated vinyl or adhesive residue. The heat opens the adhesive bond and the formula goes to work instantly.

Pro tip: Work in sections no larger than 1 sq. ft. at a time. Turn off and remove the heat gun from the work area before continuing — never use an open flame near the product.

Let It Work

30 to 60 seconds dwell time

Give Vinyl Ripper 30–60 seconds to break down the adhesive bond. You'll see the Vinyl Ripper begin to change the structure of the vinyl.

Pro tip: On thick cast vinyl or aged adhesive, let it work for up to 90 seconds and repeat steps 1 and 2.

Remove

Peel at a low angle — keep tension consistent

Once the product has been applied, the vinyl should peel away easily. For old, cracked or brittle vinyl, gently lift or scrape it off with a plastic razor blade to avoid scratching the surface.

Pro tip: Keep your pull angle low — 15 to 30 degrees. Higher angles increase the chance of tearing and leave more residue behind.

Watch It In Action

See The Process

Works On

Painted automotive surfaces
Glass and windows
Powder-coated metal
Aluminum and steel panels
Fleet vehicle graphics
Sign substrates

Use It Right

  • Wear nitrile gloves and eye protection
  • Use in a well-ventilated area
  • Keep away from open flames and heat sources
  • Do not ingest — keep out of reach of children
  • Read full SDS before use

Ready to Rip?

Get Vinyl Ripper delivered to your door.